Diamant *** specifications

comfort, speed and easy handling


Technical data

Length overall:    10.39m
LWL:    8.30m
Breadth overall:    2.50m
Draught:    1.80m
  alternative:    1.65m
  Lifting keel (extra)    1.25/1.75m
Displacement    2.85to
Mainsail:  28.00m2
Self tacking jib:  20.00m2
Top-Gennaker:115.00m2
Designer:Dipl.-Ing.
Arch. A. Ott
Diamant*** sail planDiamant*** sail plan

Hull

The hull is made using a stable sandwich construction made of glass-fibre reinforced polyester with Divinycell foam. All laminates are hand-laid. The standard hull comes in white with a wide, single boot-top in grey. In the keel area, a galvanised steel frame for the keel suspension is also firmly laminated in.

Deck

The deck is also made using a stable sandwich construction with an inserted anti-slip structure on the tread surfaces and the deckhouse roof. The anti slip structure on the deck is grey.

Keel and rudder

keelkeel

The keel is a 1.80 m deep fixed keel with a ballast bulb. The ballast bulb is made of lead and the keel shaft consists of polyester concrete. The ballast bomb is 2.20 m long, 20 cm high and 35 cm wide. This results in a higher level of efficiency. The entire keel weighs 1,000 kg. Optionally, we can equip the boat with a keel that is 1.65 m deep. A hydraulic lifting keel from Speedwave, with a variable draught of 1.25 m to 1.75 m is available as an accessory at additional cost. The hydraulic lifting facility is fully integrated in the keel. This means that there is no keel box in the cabin, freeing up space for other use. The keel is operated using an electro-hydraulic mechanism.

The elliptical balance rudder is equipped with a 40 mm Niro rudder shaft and has a depth of 1.45 m. An autopilot, which is entirely invisible from the outside, is installed below deck, directly at the rudder shaft, and it can take over steering through the press of a button.

Engine

engineengine

The DIAMANT*** is delivered with a 10 hp two cylinder diesel engine with closed cooling (Nanni 2.10 diesel) as standard. The engine is shaft driven and has a Gori folding propeller and fulfils the relevant emission regulations for inland waters, including Lake Constance. The starter motor for the engine provides 12 Volt and 75 AH. The diesel tank holds approx. 30 litres and is located in the port locker. The switch is located in the cockpit and is by Spinlock with a removable lever as standard, and the diesel tank gauge can be found next to the engine electrical panel. Optionally available: Kräutler electric motor with 4.40 kW, 48 Volt with 4 batteries with 120 AH each, including a 240 Volt shore-side electrical installation with a FI circuit breaker, a battery charger and a 12 Volt converter for the 12 Volt on-board power supply.